Milwaukee M18 Cordless Hackzall Review 2625-21


Milwaukee M18 Cordless Hackzall Review 2625-21: What Is A Cordless Hackzall?

A cordless hackzall is a type of device which uses electricity instead of compressed air to fire bullets at targets. They are used primarily in urban warfare situations where a gun may not be available or practical due to terrain, weather conditions, or other factors. The most common types of corded hacksaws are those made by Makita and Bosch. These devices use a motor to turn a blade attached to a long wire. When the wire is cut, the cutting action causes the blade to spin and cause metal fragments (bullets) to fly out of it.

The Milwaukee M18 Cordless Hackzall Review 2625-21: How Does It Work?

When you pull back on the trigger, a small electric current flows through the battery pack located inside your rifle’s stock. This current turns a solenoid valve which opens up a tube connected to the battery pack. Inside this tube is an electrical circuit with wires running from one end to another. When the wire carrying current passes over a certain resistance, it causes the valve to open and allow some gas (air) into the tank. The gas then pushes against a piston inside the tank causing it to move forward when pressure is applied by hand or lever. When the trigger is released, the solenoid valve closes off the tube and stops gas from being forced into the tank.

The gas pushes the piston which causes a small metal disk with a sharp edge on one side (called a diaphragm) to move forward with enough force to cut through metal and produce fragments (bullets). Some of these fragments are small and inconsequential while others are large enough to inflict lethal damage on any living creature they hit.

The Milwaukee M18 cordless hackzall review 2625-21 can fire up to 1,800 bullets per minute. This makes it the perfect tool for use in urban combat situations where cover fire is needed to suppress the enemy.

Is It Easy To Use?

This rifle is extremely easy to use and operates very much like a paintball gun or BB gun. Most users can master the basics of using this weapon within minutes of practice. The rifle can be loaded with a 20 or 30 round magazine of metal fragments. It is recommended that you don’t attempt to use the maximum capacity because this will most likely cause jams and other issues.

The only other thing to remember is to keep the trigger pressed in all the way when you are firing. The gun may require you to pull it with more force than you would think.

When the trigger is pulled and held, the metal disk with the sharp edge on it (called a diaphragm) immediately moves forward at high speed. This creates an initial boost of gas into the tank. After that first boost of gas is used up, a new charge of gas enters the tank and pushes against the original charge that is still being forced out of the tank by the piston. The combined force of the new and old gas then pushes against the projectile (bullet).

This rifle does not have any adjustable parts, but it also doesn’t need them. It comes with a built-in safety switch on the back that prevents the gun from firing when it is engaged.

The power cord is up to 15 meters long, which allows you to move around in the heat of battle while staying connected to your source of energy.

This rifle is a very powerful tool for combat and can be used by both military and law enforcement units. It is also a great addition to your airsoft collection or your own personal arsenal.

Is It Safe?

The M18 rifle is considered to be a very safe weapon to use and operate. The only major safety concern is the high pressure that builds up inside the gun when gas is forced into the tank. This can cause the gun to explode or launch parts with enough force to cause serious injury if the user is not using the weapon properly.

It is also important to remember to keep your fingers away from the trigger when the gun is not in use. This safety precaution should always be taken with any gun.

What’s Included?

When you purchase the M18 cordless hackzall review 2625-21, it comes with the rifle, 2 batteries, a charger, and 2 magazines. Each magazine holds 30 metal fragments.

Additional magazines and batteries can be purchased separately when needed. You can also buy a 3-round burst add on that allows you to change the rifle from full to semi-automatic.

The gun requires 8 AA batteries (sold separately) to power the electronic features of this weapon. These batteries are required in order to ready the gun for firing.

The battery compartment is located at the stock of the gun and is labeled as such.

Milwaukee M18 Cordless Hackzall Review 2625-21 - Image

The battery compartment has a cover that will open and close. The safety switch is located on this cover and must be in the on position for the gun to fire properly.

The switch is clearly labeled with an illustration showing it in the on position.

How to Operate Make sure that the safety switch is in the on position.

Make sure that the batteries are properly installed in their compartment. The cover will not close if the batteries are not properly placed inside of it.

Move the charging lever on the top right side of the gun to the rear position. This charging position will draw a charge from the batteries and send it into the gun’s internal mechanisms.

The indicator light near the lever will turn red when in this position. You will know that the gun is ready for use when the light turns green. Turn it off when you are finished using it.

The trigger is the standard semi-automatic mode. Pulling it will only fire one shot at a time until it is reset.

How to Load and Fire

To load the weapon, the bolt should be in the open position. This can be done by pulling it back manually with your hand or pushing it forward with your foot if you’re using the bipod that is built into the gun.

Milwaukee M18 Cordless Hackzall Review 2625-21 - Image

The magazine can then be loaded with the metal fragments that are included with the gun. These do not need to be loaded into the magazine in a special way.

Simply press them down into the chamber of the gun and you’re ready to go.

When you’re ready to fire, aim at your target and then pull the trigger. Make sure to only pull it once because it fires as a single shot when in semi-automatic mode.

The gun is equipped with a bipod for increased stability when shooting. The bipod can be extended out and then locked into place when you’re ready to shoot.

The gun is fairly heavy so it will remain steady even when fired on the move if you use the bipod.

The gun is equipped with a retractable stud that can be used to secure the gun to almost any surface. This can be used to steady the gun when fired from the hip or when using the bipod for a stationary shot.

The stud can be extended or retracted by pulling or pushing the stud’s button located on the right side of the gun.

Once extended, the stud can be secured to almost any surface by pressing it into the desired location and then pressing the button on the side of the gun a second time. If you decide that you no longer want it attached, simply press the button a third time and it will detach from the surface.

Remember, if using the stud to steady your shot, make sure that you are attaching it to a sturdy surface before firing.

When finished firing, make sure to always remember to turn the safety on and store your weapon.

Milwaukee M18 Cordless Hackzall Review 2625-21 | realmanguide.net

Watch a video showing how to operate the gun.

Back to the weapons page

Sources & references used in this article: